5 Best Practices for Efficient Vacuum Excavation In digging, numerous ways of excavation are used. Some are older methods that are more traditional in nature while others are more modern. On account of drilling companies using these new methods, digging has become easier, faster and safety is more assured than in the past. An example is the vacuum excavation method that uses either water or air in the process. Here are some tips and practices for efficient vacuum excavation. There are some soils that are hard-packed and heavy, where air cannot penetrate well. In situations like that, the use of water, or hydro excavation is the best alternative. In contrast, where the soil might be loose, sandy and with a lot of gravel, dry or air excavation is advised. Hydro excavation uses water pressure that damages old pipes and electric wires that are brittle, thus dry excavation is deemed as the safer choice. It’s important to take into account the size of the truck to be used in the excavation in relation to the size of the vacuuming pumps. If the vacuum power created for the digging is to be strong enough, then the size of the air or water tank must correspond to the size of the vacuum pump. This means that if a lot of vacuum power is needed, then both the tank for holding air or water and the pump should be equally large. Where there is going to be excavation using both wet and dry methods of excavation, then you are going to need above average tanks. However much vacuuming, whether dry or wet, is considered to be safe than old fashioned digging methods, safety issues must be addressed. Training on safety measures while handling machines should be put into place. Some modern machines cannot be put to work without the necessary specialized training of the potential users. Therefore, the people going to use them must be taught how to operate them. Workers should be knowledgeable on how to avoid damaging underground utility pipes and power lines. Proper gear and clothing is a necessity for workers. These include hand gloves and dielectric boots. Precision is gotten from using the vacuuming method to dig. Accidents can sometimes occur in the excavation process. This can be caused by mistakenly digging in the wrong site due to wrong identification process or human error. Mistakes of this kind may lead to explosions from gas leaks and electrocutions. By reaching out to the concerned authorities, it will help in ensuring you are digging at the correct site and you will also be given maps. Proper maintenance of the vacuum trucks and the pumps used by the drilling company must be observed. This makes sure the machines perform according to their maximum ability. Tear and wear often occurs to machines that are being used, so close monitoring should be paramount. Regular oiling of the machines, especially the moving parts is vital. Parts like nozzles and hoses need regular examination. Following these best practices will help ensure efficient vacuum excavation.
Where To Start with Services and More Posted on 23/06/2017